![]() That was it! fancontrol works perfectly now and starts at boot time. maxX minX Action: The action component of our problem is simply in. # echo "Configuration is too old, please run pwmconfig again" >&2 above, we use the linux system command iostat 20 that. How you can install these programs depends on the linux distrubution you are using. Notes on compiling/installing If you want to use the fan control utility then you first have to compile it using cmake and g++. Its just a simple configuration change detector! since, I had specified the absolute paths for my sensors, not only was this not necessary, it was actually causing the error. 6 years ago README.md HP-625-Linux-Fancontrol Fancontrol under Linux for HP-625 Notebooks for latest kernel versions. I found the cause at lines 302-307: # Check for configuration changeĮcho "Configuration is too old, please run pwmconfig again" >&2 So I decided to take a look at /usr/sbin/fancontrol to see why. This causes the error Configuration is too old, please run pwmconfig again Due to motherboard limitations, my sensors are defined as absolute paths. When starting fancontrol via #service fancontrol start or #fancontrol, the errors of /usr/sbin/fancontrol are not printed. Also, many thanks to for advice and pointing me in the right direction. Here is the answer just incase I mess this up or anyone else has the same problem. I feel silly, should've investigated more. Start-stop-daemon -stop -quiet -pidfile $PIDFILE -oknodo -startas $DAEMON Log_warning_msg "Not starting fancontrol run pwmconfig first." 1K Share 71K views 4 years ago Fix all your heat. Log_failure_msg "Not starting fancontrol, broken configuration file please re-run pwmconfig." conf ->editor input-> i8k Then i8kutils fan control service starts at boot. Start-stop-daemon -start -quiet -background -pidfile $PIDFILE -startas $DAEMON If $DAEMON -check 1>/dev/null 2>/dev/null then Small changes can be made by editing the config file directly following the rules above. ![]() What is the difference between starting fancontrol as a service vs manually that would cause it to fail? For initial setup I recommend using the pwmconfig script. Starting fan speed regulator: fancontrol. However when starting fancontrol as a service (at or after boot), it fails. Settings for /sys/devices/platform/it87.656/hwmon/hwmon]*/device/pwm3:Ĭontrols /sys/devices/platform/it87.656/hwmon/hwmon]*/device/fan2_input Loading configuration from /etc/fancontrol. Subsystem: Acer Incorporated HD Graphics 520Ġ1:00.When fancontrol is started from the terminal it works fine # fancontrol ![]() Please, can somebody give me a working resolution to this issue?ĮDIT: This is the output of lspci -k | grep -EA3 'VGA|3D|Display' 00:02.0 VGA compatible controller: Intel Corporation HD Graphics 520 (rev 07) I am really getting annoyed by listening to the fans always spinning. I tried those common resolutions as to change the GRUB setting to make it equal to acpi_osi=!Windows 2012, but it didn't work. The same thing happens on every Linux distro I had, but on Windows it's not doing so. ![]() I am having the issue that whenever I turn on Ubuntu (I'm using dual-boot with Windows 10), fans in my notebook will always run at full speed even when I'm not doing anything.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |